Study on Stress Distribution Law of Anchorage Body
DOI:
https://doi.org/10.62051/ijnres.v2n2.13Keywords:
Anchorage Body; Theoretical Analysis; Anchor Axial Force; Interfacial Shear Stress.Abstract
In order to reveal the stress distribution law of the anchorage body during the drawing process, through the analysis and research on the anchoring mechanism of the anchor rod, it is found that the bonding mechanism of the interface between the anchor rod and the anchoring material is mainly determined by three factors : bonding force, mechanical interlocking and friction force. The bonding mechanism of the anchorage material-surrounding rock interface is mainly determined by two factors : bonding force and friction force. Then, the mechanical model of anchorage body is established, and the distribution equations of axial force and interfacial shear stress of anchorage body are obtained by theoretical analysis. The axial force and shear stress curves are obtained by substituting the relevant parameters. It is found that the axial force and interfacial shear stress curves are exponentially decreasing. The axial force of the bolt is approximately equal to the load applied on the bolt, and at the end of the anchorage, the axial force approaches zero.
References
Yuan Liang, Xue Junhua, Liu Quansheng, et al. The surrounding rock control theory and support technology of deep rock roadway in coal mine [J]. Coal Journal, 2011,36 (04) : 535-543.
Kang Hongpu, Wang Jinhua, Lin Jian. Analysis of application examples of bolt support in coal mine roadway [J].Journal of Rock Mechanics and Engineering, 2010,29 (04) : 649-664.
Kang Hongpu, Wu Yongzheng, He Jie, et al. Research and practice of bolt support in deep rock burst roadway [J]. Coal Journal, 2015,40 (10) : 2225-2233.
Wu Yongzheng, He Jie, Wang Yang. Research on failure mechanism and control technology of large section rock burst roadway [J].Coal Science and Technology, 2018,46 (01) : 61-67.
He Manchao, Guo Zhibiao. Mechanical properties and engineering application of constant resistance large deformation bolt [J].Journal of Rock Mechanics and Engineering, 2014,33 (07) : 1297-1308.
Zhang Lewen, Wang Ren. Current status of research on geotechnical anchorage theory [J]. Geotechnical mechanics, 2002 (05) : 627 - 631.
Hu Bin. Study on mechanical properties of full-length prestressed anchor resin anchoring agent [D] : China Coal Research Institute.
Cui Qianli.Research on anchorage performance and influencing factors of resin bolt [D] : China Coal Research Institute, 2010.
Huang Minghua, Zhou Zhi, Ou Jinping. Non-linear full-history analysis of pulling force on anchorage section of tensile anchor [J]. Journal of Rock Mechanics and Engineering, 2014, 33(11): 2190-2199.
Huang Minghua, Li Jiacheng, Zhao Minghua, et al. Nonlinear analysis of pullout load transfer of anchor rod in layered foundation [J]. China Journal of Highways, 2019,32 (01) : 12-20.
Yang Zejun. Study on seismic vulnerability and safety risk of anchored sheet-pile retaining wall structure [D] : Chongqing University, 2019.
Benmokrane B, Chennouf A, Mitri H S. Laboratory evaluation of cement-based grouts and grouted rock anchors[J]. International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts, 1995, 32(7): 633-642.
Gao Danying, Zhu Haitang, Xie Jingjing. Bond-slip constitutive model of fiber reinforced plastic reinforced concrete [J].Industrial building, 2003 (07) : 41-43.
Fu Shixiong. Study on the mechanism of in-situ drawing and equivalent pre-tightening force of coal bolt [D] : China University of Mining and Technology, 2017.
Downloads
Published
Issue
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
