Coupling effect of nano-tribology and biomechanics based on siphon phenomenon
DOI:
https://doi.org/10.62051/qjr0z463Keywords:
siphon phenomenon; Coupling effect; nano-tribology; biomechanics.Abstract
Nano-tribology focuses on the phenomena of friction, wear and lubrication at nano-scale, while biomechanics studies the response of objects and biomaterials under mechanical load. Through theoretical analysis, experimental operation and numerical simulation, this study comprehensively discusses the influence of siphon phenomenon on tribology and biomechanics at nanometer scale. Gold nanoparticles, silica nanoparticles and polymer nanoparticles were selected in the experiment. HeLa cells and primary cells were taken as biological samples, and the friction between nanoparticles and cells and the elastic modulus of cell membrane were quantified by using high-precision equipment such as atomic force microscope (AFM) and nano-indentation instrument. The results show that the siphon phenomenon significantly enhances the friction between nanoparticles and cell membrane under high humidity, and the increase of friction is positively correlated with the elastic modulus of cell membrane. It is found that the friction between gold nanoparticles and cells is generally higher than that between silica and polymer nanoparticles under the same humidity, which may be related to the physical and chemical properties of nanoparticles. This study not only reveals the close coupling relationship between nano-tribology and biomechanics, but also provides theoretical basis and experimental reference for the application of nano-biomedicine.
Downloads
References
[1] Fior, R. , Kwok, J. , Malfatti, F. , Sbaizero, O. , & Lal, R. (2015). Biocompatible optically transparent mems for micromechanical stimulation and multimodal imaging of living cells. Annals of Biomedical Engineering, 43(8), 1-10.
[2] Nagy, G. G. , Inna.Székács, Attila.Bonyár, & Horvath, R. (2022). Cell-substratum and cell-cell adhesion forces and single-cell mechanical properties in mono- and multilayer assemblies from robotic fluidic force microscopy. European journal of cell biology, 101(4), 151273.
[3] Michaela Sojková, Karol Vegso, Nada Mrkyvkova, Jakub Hagara, Peter Hutár, & Alica Rosová, et al. (2019). Tuning the orientation of few-layer mos 2 films using one-zone sulfurization. RSC Adv., 9(51), 29645-29651.
[4] Arif, Taib, Colas, Guillaume, Filleter, & Tobin. (2018). Effect of humidity and water intercalation on the tribological behavior of graphene and graphene oxide. ACS applied materials & interfaces, 10(26), 22537-22544.
[5] Kwon, S. K. , Kim, H. D. , Pei, X. Q. , Ko, H. E. , Park, H. W. , & Bennewitz, R. , et al. (2019). Effect of cooling rate on the structure and nanotribology of ag–cu nano-eutectic alloys. Journal of Materials ence, 54(12), 9168-9184.
[6] Xiong, S. , & Wang, R. T. (2022). Tribological of eu-doped wo3 coated with sio2 transfer film formation on sliding surface. Surface Engineering, 38(10/12), 930-938.
Downloads
Published
Conference Proceedings Volume
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.