Research on the Retention of Small Coal Pillars in Goaf Excavation Along the Fully Mechanized Mining Face

Junxiao Han

doi:10.62051/ijnres.v6n3.13

Authors

Junxiao Han

DOI:

https://doi.org/10.62051/ijnres.v6n3.13

Keywords:

Digging Tunnels Along the Air; Small Coal Pillar; FLAC 3D Numerical Simulation.

Abstract

In order to solve the problems of coal pillar retention and closure in the fully mechanized mining face, this paper takes the 208 fully mechanized mining face of Daning Coal Mine as the prototype, and studies the width of small coal pillars left in the goaf of the 208 fully mechanized mining face of Daning Coal Mine through a combination of theoretical analysis and numerical simulation. The minimum size of coal pillars in each section is about 2.8-5.0m; By using FLAC 3D numerical simulation software to simulate and analyze the numerical values of different coal pillar settings, it was finally concluded that setting a 6m coal pillar resulted in the most stable bearing structure of the roadway itself.

References

[1]KANG Hongpu, XU Gang, WANG Biaomou, et al. Forty years development and prospects of undergroundcoal mining and strata control technologies in China[J]. Journal of Mining and Strata Control Engineering, 2019, 1(2): 7-39.

[2]WU Yajun, WANG Yajun, YANG Shuxin, et al. Study onunderground pressure appearance and control technology ofroadway near goaf with small coal pillar in extra thick coalseam[J]. Coal Technology, 2021, 40(6): 33-37.

[3]WANG Rui. Study on reserved width of small coal pillar andsupporting optimization in working face of coal mine[J]. China Energy and Environmental Protection, 2023, 45(5): 284-288.

[4]HE Wenrui, HE Fulian, CHEN Dongdong, et al. Pillar and surrounding rock control of gobside roadway with mechanical caved mining in extrathick coal seams under hardthick main roof[J]. Journal of Mining Safety Engineering, 2020, 37(2): 349-358+365.

[5]LIU Jiayu, Study on mine pressure behavior rule in fullymechanized working face of thick coalsem [J]. Energy Technology and Management, 2022, 47(5):114-116.

[6]ZHANG Wencai, SUN Xiaolong, SUN Lihui. Study on thewidth of narrow coal pillars along the thick coal seam in thegob-side entry[J]. Coal and Chemical Industry,2021,44(9)14-16+19.

[7]REN Jianhui,WANG Fan, WANG Wen. Study on thewidth of small pillar for gob side entry driving in sectionalcoal pillar in fully mechanized top coal caving face in thickseam[J].China Coal,2022,48(1):275-282.

[8]WANG Xingyao, DU Shuyu. Determination of small coalpillar parameters in goaf excavation of excavation of fullymechanized caving face in tongxin coal mine[J]. Coal Science &.Technology Magazine, 2022, 43(6): 44-48+52.